P80 magwell instructions

Carbon Polymer Solutions P80 Magwell Install Instructions

1. Remove allen set screw.
2. Slip front of grip into magwell under the small lip as shown in picture
3. 
4. Use index finger to apply little pressure to tab to pop it in place as shown in photo
5. 
6. Important this step doesn’t require much force at all if you have a issue check that the front is in the groove properly.
7. Slip magwell into place and install screw with a dab of blue Loctite. DO NOT over tighten screw just needs to be below the grip over tightening will distort magwell causing mag feeding issues.
8.